Air and dust handling
Centrifugal Aspirator
Captures dust at the source. Keeps the line clean. Single-inlet radial extraction for grain, feed, flour, wood and chemical dust. Airflow, pressure and motor are sized together, never the casing alone.
35,000 m³/h
max airflow
5,000 Pa
max pressure
0.37 – 30 kW
motor power
AISI 304
casing option
Why is extraction sized as a whole?
Airflow, pressure and motor depend on each other. The same casing runs with different motors and speeds, so a selection based on casing size alone is not valid.
Once the dust load, number of pick-up points and duct diameter are known, the duty point is read from the fan curve. The motor is not oversized in the process.
- ›Airflow: the air volume the line must move.
- ›Pressure: duct and filter resistance.
- ›Motor: the power those two demand.
Which dusts does it handle?
Grain, feed, flour, wood and chemical dust. For abrasive or sticky dust the casing lining and impeller material change with the project.
The inlet damper sets airflow on site, balancing product loss against energy consumption.
Where does it sit on the line?
The aspirator goes as close as possible to the dust source. Long duct runs raise pressure loss and motor size. Right or left-hand outlets simplify site layout.
Highlights
- Single-inlet radial fan
- Radial, backward-curved impeller
- Direct coupled or belt-driven
- Adjustable inlet damper
- Right or left-hand outlet
- Custom casing finishes
Technical specifications
- Airflow
- 1,000 – 35,000 m³/h
- Pressure
- 300 – 5,000 Pa
- Motor power
- 0.37 – 30 kW
- Speed
- 1,400 / 2,800 rpm
- Impeller
- Radial, backward-curved
- Casing
- St37; AISI 304
- Drive
- Direct coupled / belt-driven
- Damper
- Adjustable inlet damper
Frequently asked questions
What airflow does it deliver?+
The range is 1,000 – 35,000 m³/h with a maximum of 35,000 m³/h. The duty point follows the line resistance.
How is the motor selected?+
Motor power from 0.37 to 30 kW is calculated together with airflow and pressure. Casing size alone is not enough.
What is the casing material?+
Standard casing is St37 steel; AISI 304 stainless steel and custom finishes are built to order.
Is a right or left-hand outlet available?+
Yes. Right or left-hand outlets and alternative discharge directions are built per project.
Centrifugal Aspirator
Single-inlet centrifugal aspirator: 1,000–35,000 m³/h airflow, 300–5,000 Pa pressure, 0.37–30 kW motor, St37 or AISI 304 casing. Grain, feed, flour and chemical dust.
